I know it doesn't look like much, but this is 2 separate prints fused into one

submitted by
I know it doesn't look like much, but this is 2 separate prints fused into one

The only tell is a slight bump on the seam line of the back. It’s 0.1mm layer heights and 0.6mm thick.

Printed in TPU, I was looking for a solution like this for a future project and wanted to share it with someone.

14
51

Back to main discussion

Oooh that’s cleverrr… Great job! Definitely coulda used this technique a few times in the past if I’d ever thought of it

 reply
2
OP

I think it’s limited in use but if you have a flat and thin stretch on your part, it could work.

 reply
2
Insert image